PROPERTIES

Losetas FLEXIFOR

FLEXIFOR manufactures rubber tiles for fall cushioning, mixing recycled and "calibrated" rubber with binder resins. With these components and through a controlled crosslinking process, it achieves a contrast-quality tile.

Technical Characteristics

  • Elastic floor.
  • Cushioning and shock absorption.
  • Permeability to water, do not soak and dry quickly.
  • Non-slip in both dry and wet conditions.
  • Resistance to the elements.
  • Sound absorbent and vibration absorbent.
  • Thermal insulation.
  • Easy cleaning.
  • Good dimensional stability.
  • Resistant to adverse weather conditions.
  • The rubber product and granules used do not contain dangerous and toxic substances, according to the provisions of the Directive 200/33 CE.

STORAGE AND PACKAGING

  • Allows packing with other materials. Do not store at temperatures above 70°C.

CLEANING

  • FLEXIFOR tiles are cleaned with water and conventional cleaning products. It is not recommended to use corrosive products.

NORMATIVE

  • Complies with the regulations UNE-EN 1177
  • HIC 0.7 20 mm
  • HIC 1.3 43 mm CERTIFIED BY ACCM (ENAC accreditation)
  • HIC 1,6 60 mm
  • HIC 1,8 80 mm

The tiles must be placed on a flat surface that occupies the whole surface that is desired to pave. It is advisable to prepare a flat surface of concrete or compacted earth, in order to obtain a suitable drainage

Surfaces should be conveniently prepared with corresponding falls to allow the evacuation of water and prevent the formation of puddles under the pavement. Subsequently, tiles are attached to others to obtain a bonded surface. To do this, it is recommended to use a suitable adhesive, which binds the interior with the floor (in small quantity and in the corners) and especially the tiles with each other.

It is important that the assembly is made in such a way that the damping surface does not offer possibilities of entrapment to the users.

FIRST

Apply the adhesive through the cannula, on the side surfaces of the tiles. Then join against the adjacent faces. The surfaces must be in contact with each other in a forceful way, to ensure a correct gluing.

SECOND

Once the first gluing is ok, the adhesive is applied again at the corners of the plates, as shown in the upper figure by circles.

Room Dimensions

Excepteur sint occaecat cupidatat non proident, sunt in culpa qui officia deserunt

Room Dimensions

Excepteur sint occaecat cupidatat non proident, sunt in culpa qui officia deserunt

Room Dimensions

Excepteur sint occaecat cupidatat non proident, sunt in culpa qui officia deserunt

Room Dimensions

Excepteur sint occaecat cupidatat non proident, sunt in culpa qui officia deserunt